Skip to content

Industry solutions

Components for programmes where failure is expensive

We align materials, tolerances, inspection and packaging with the standards of your industry — from IATF 16949 automotive documentation to clean-room-ready medical packaging.

Automotive & EV

IATF 16949 components with PPAP discipline

Automotive & EV

Drivetrain housings, battery-frame plates and structural fasteners for automotive and electric-vehicle programmes, documented to IATF 16949 and delivered on a scheduled call-off.

Typical challenges

  • PPAP and capability evidence required before SOP
  • Weight reduction without sacrificing crash performance
  • Zero-defect expectations at volumes above 100,000/year

How TradeMax responds

  • APQP-aligned project gate reviews with a named project engineer
  • Poka-yoke fixtures and 100% functional checks on safety-critical features
  • Buffered safety stock and weekly call-offs from Ningbo
Renewable Energy

Balance-of-system parts for solar, wind and storage

Renewable Energy

Mounting brackets, structural fasteners and fluid assemblies for solar racking, wind turbine internals and battery energy storage systems, finished for 25-year outdoor exposure.

Typical challenges

  • Corrosion resistance over a 25-year service life
  • Seasonal demand spikes that strain capacity
  • Landed cost pressure from large, low-value parts

How TradeMax responds

  • Hot-dip galvanising and zinc-flake finishes validated by salt-spray testing
  • Kanban stock built in the low season for Q2/Q3 call-offs
  • Nesting and tooling optimisation to protect unit cost
Industrial Automation

Housings, shafts and cabinets for 24/7 operation

Industrial Automation

Sensor housings, precision shaft pairs and control cabinets for machine builders, robotics integrators and factory automation — engineered for continuous duty and fast field replacement.

Typical challenges

  • Short product life cycles and frequent drawing revisions
  • Field failures that must be traced to a specific lot
  • Late design changes before a trade-show launch

How TradeMax responds

  • Revision-locked inspection plans; every change re-quoted in writing
  • Serialised shafts for traceable field replacement
  • Fast-track 10-day route for urgent prototype revisions
Medical Equipment

Cleanable components with full material traceability

Medical Equipment

Machined housings, shaft assemblies and structural plates for imaging, diagnostic and laboratory equipment, with cleanroom packaging and material certificates to EN 10204 3.1.

Typical challenges

  • Cleanability and resistance to repeated disinfection
  • Documentation for design-history-file audits
  • Small batches with high mix and tight launch dates

How TradeMax responds

  • Electropolished, crevice-free surfaces with Ra 0.4 on wetted parts
  • Material and process traceability retained for 10 years
  • Cleanroom bagging and lot-controlled shipments

Discuss your programme

Share your drawing package and annual volumes. We will propose a manufacturing and inspection plan that fits your qualification requirements.

Industry solutions

Discuss your programme

Share your drawing package and annual volumes. We will propose a manufacturing and inspection plan that fits your qualification requirements.