Skip to content

Engineering

CNC Machining Tolerances: How to Specify Them Without Overpaying

Every tolerance on a drawing is a cost instruction. Here is how to separate the dimensions that matter from the ones that quietly double your part price.

By Lena Zhou · Head of Manufacturing Engineering8 min readPublished 2026-10-08

A CNC machine does not decide what a part costs. The drawing does. Every tight tolerance adds inspection time, slower passes, more scrapped parts and, often, an extra finishing operation. Buyers who understand which tolerances actually drive cost consistently pay less for the same function.

Start with function, not with a default

The most common mistake we see is a title-block tolerance of ±0.05 mm applied to every dimension. That is cheap for a 20 mm bracket and expensive for a 300 mm machined plate, where holding ±0.05 mm over the full length requires temperature control and additional finishing passes. A better approach is to ask what the dimension does: locates a bearing, seals a fluid, sets an appearance gap, or merely clears a neighbouring part.

Which tolerance bands actually change the price

BandTypical processRelative costAppropriate use
±0.2 mmStandard milling or turning1.0×Clearance, covers, non-critical brackets
±0.05 mmCNC with finish pass1.2–1.4×General machined interfaces
±0.01 mmControlled shop, CMM inspection1.6–2.2×Bearing seats, mating faces, sealing grooves
±0.005 mmGrinding, temperature control, 100% inspection2.5–4.0×Only where fit or function provably requires it

These multipliers are indicative, not a price list. Geometry, material and batch size matter as much as tolerance. A thin-walled aluminium part at ±0.01 mm can be harder to produce than a rigid steel part at ±0.005 mm, because deflection during clamping, not machine accuracy, becomes the limiting factor.

How to call out tolerances so suppliers quote accurately

  • Give every critical dimension its own tolerance; avoid a blanket title-block value below ±0.1 mm.
  • Reference the inspection method where it matters — CMM, gauge, or functional test.
  • State the datum scheme explicitly; ambiguous datums are a frequent source of dispute.
  • Mark appearance-critical surfaces and say whether tool marks are acceptable.

A worked example

A sensor housing had a ±0.02 mm tolerance on the overall 120 mm length, used only to align a cosmetic end cap. The functional requirement was a flat sealing face and a centred bore. By moving the overall length to ±0.1 mm and keeping ±0.01 mm on the bore and ±0.02 mm flatness on the seal face, machining time fell by 18% and the scrap rate from 4.1% to 0.6%, with no effect on assembly.

A tolerance that cannot be traced to a function is usually a cost that cannot be traced to a benefit.

What to send us

Send the drawing, the annual volume and a short note on what each tight dimension does. We return a DFM review that separates must-hold tolerances from ones that can be relaxed, with the cost effect of each change. It takes two business days and usually pays for itself on the first order.

Start a project

Send us your drawing. Get a real answer.

Upload a STEP, DWG or PDF drawing and our engineering team will return a feasibility review, tolerance feedback and indicative pricing within two business days.